CS Cavity slider systems use a strong cavity frame constructed of high
grade aluminium with pine nogs, top-hung track and carriage system suitable for
installation into timber, steel, concrete or masonry construction where a fire resistance rating is not required.
CS Cavity Sliders are
available for single or double sliding doors in a range of standard sizes or
can be made to measure up to very large sizes.
All aluminium components, screwed together for strength and reliability.
Door and carriages can be removed without removing wall linings.
- Door cannot jump off the track.
- Supplied fully assembled for on-site installation.
No visible floor guides.
- Customisable with a wide range of detail options
Jamb options: Timber flat (for architraves) or grooved (for wall
linings), aluminium (powder coated or anodised)
Scope of use
CS Cavity Sliders units have been appraised for use with sliding doors
in internal locations in residential, commercial and light industrial
New Zealand Building Code (NZBC)
The product will, if employed in accordance with the supplier's installation and maintenance requirements, assist with meeting the following provisions of the building code:
- Clause B1 Structure: Performance B1.3.1, B1.3.2, B1.3.3(a), B1.3.3(f), B1.3.3(j), B1.3.4
- Clause B2 Durability: Performance B2.3.1, B2.3.1(a), B2.3.1(b), B2.3.1(c)
- Clause F2 Hazardous building materials: Performance F2.3.1
The product has and can make available the following additional evidence to support the above statements:
Use in Service History
CS Cavity Sliders have been successfully used in commercial, residential and institutional projects in New Zealand and Australia since 1986. CS Cavity Sliders are backed by a 10 Year Written Guarantee.
Refer to the CS FOR DOORS
Specification Guide for design parameters. Units can be supplied with timber
jambs or prefinished powdercoated aluminium jambs in a variety of colours.
CS Cavity Sliders are
designed to fit standard stud walls (nominally 100 mm). Options are also
available for 70 mm, 94 mm and 140 mm stud walls. An intermediate stud is
included in the framing for stability in all units for doors wider than 920 mm.
CS Easyopen units require a
minimum door width of 910 mm.
sizes, timbers and profiles are available on request.
CS Cavity Sliders can be specified with almost
any choice of door, including aluminium CS DoorLeaves. Door carrying capacity: 90kg using standard 2-wheel carriages. 4-wheel carriages are supplied for
CS Cavity Sliders must be installed in accordance with the
manufacturer's installation instructions. Lintels over the full trim size
(opening and pocket) should be sized to ensure that no load is applied to
the door assembly. Lintels to NZS3604 are acceptable for door weights up to
75kg per metre width of door. Specific design required when the door
weight exceeds 75kg per metre.
Track must be fitted level and straight and fixed at maximum 600mm
centres to the lintel.
Refer to CS FOR DOORS detailed instructions for preparation and
finishing of the door opening and final door installation.
Refer to CS FOR DOORS detailed instructions on powder coated aluminium
Under normal circumstances, CS Cavity Sliders require no maintenance.
In high use situations, the carriages will eventually need replacing.
Replacement carriages and instructions on replacement are available from CS FOR DOORS.
Any service requirements should be referred to one of our four branches
Ten year written warranty on CS Cavity
CS FOR DOORS is 100% New Zealand owned and all products are 100% New Zealand made.
CS FOR DOORS operates a
zero waste policy with all metal offcuts and waste recycled. Timber components
are made from pine from sustainable resources.
||New Zealand Made