Hyne I-Built™ 17c glue laminated beam
Product Technical Statement: 105433
Commonly used as lintels, bearers, roof beams, rafters, curves, columns and portal frames
||Level of assurance needed to demonstrate NZ Building Code Compliance
Supporting documentation should include self-assessment and technical information by manufacturer
||Hyne I-Built™ confirms that this minimum level of assurance has been met or exceeded by the following:
Beam 17 is the ideal alternative to steel and is the strongest pine glue laminated beam available, making it well suited to a variety of critical load, long span applications.
Readily available, in a range of commonly used sizes and lengths.
It is much easier to install than steel and other engineered alternatives.
Architects and building designers can specify Hyne Beam 17C with confidence, knowing that Hyne Design (HD7) software provides assurance of the correct size for the required application.
Scope of use
In conjunction with timber or lightweight steel framing that complies with the NZ Building Code, or for existing buildings, where the designer and/or installer have established that the existing structure is suitable for the intended building work.
To the requirements of NZS 3604 as referenced in and amended by B1/AS1.
Fixing material to be in accordance with section 4, NZS 3604:2011.As part of the primary structure.››
Beams must only be used in fully enclosed internal locations excluding wet areas.
The Beam must not form any part of the external envelope (including walls).
Before or during construction, the Beam must not be exposed to the environment for more than 90 days.
New Zealand Building Code (NZBC)
The product will, if employed in accordance with the supplier's installation and maintenance requirements, assist with meeting the following provisions of the building code:
- Clause B1 Structure: Performance B1.3.1, B1.3.2, B1.3.3, B1.3.3(b), B1.3.3(g), B1.3.3(h), B1.3.3(j)
- Clause B2 Durability: Performance B2.3.1, B2.3.1(a)
- Clause C6 Structural stability: Performance C6.3, C6.4
- Clause F2 Hazardous building materials: Performance F2.3.1
The product meets the requirements set out in the following documents, or relevant parts of cited standards within the documents:
Hyne Timber’s Glue Laminated Timber (GLT) has been
independently certified by Bureau Veritas, a JAS-ANZ
accredited third-party Certification Body, under their ‘S’
Mark Product Certification Scheme.
The ‘S’ Mark is an
Australasian stamp of assurance, confirming to the design
and construction industry that Hyne Timber’s GLT is audited
and certified to the applicable Standard ‘AS/NZS 1328.1:1998,
Glue Laminated Structural Timber’.
The product has and can make available the following additional evidence to support the above statements:
For Design Guidelines refer to:
For Installation requirements refer to:
Hyne 17C Glulam beams are to be used in enclosed locations or as internal visual structural members so there is no specific maintenance required.
Any Warranty or manufacturing issues please contact IBuilt New Zealand Wood Products for assistance.
PEFC Certified Product
||Date last validated: 17 May 2022
||Date last updated: 17 May 2022
The Product Technical Statement (PTS) template is copyright to Construction Information Limited. However the content of this PTS is the responsibility of the product manufacturer/supplier.
Refer to the miproducts Terms and Conditions
|New Zealand Wood Products Limited
NZWOOD supply some of the highest quality specialist engineered wood products to the New Zealand construction industry and around the world.
||Glue Laminated Lumber