Superior materials and design make Alumat AL10 Interlock the best choice for intense wear entrance matting.
Made from exterior grade magnesium alloy and anodised it is made to last and stay looking good.
Infills, manufactured by Vebe in the Hetherlands, do not shrink back and come in a range of colours. The infills not only absorb moisture from footwear, but are ribbed to assist dirt removal. Solid construction with the entire base rubber lined with no air cavities ensure a 'clatter-free' operation on level surfaces.
Scope of use
Suitable for busy commercial entrance ways, including schools, shopping centres, offices etc. Ideally placed inside entrances or sheltered exterior situations to stop water and dirt entering premises, as well as providing an attractive welcome,
Non shrinking tight loop polypropylene infills are hard wearing and designed to keep performing.
For weather exposed areas where increased water removal is required, see the ALUMAT draining range, AL10D or AL15HDD.
New Zealand Building Code (NZBC)
The product will, if employed in accordance with the supplier's installation and maintenance requirements, assist with meeting the following provisions of the building code:
- Clause B2 Durability: Performance B2.3.1(c)
- Clause C3 Fire affecting areas beyond the fire source: Performance C3.4(b)
- Clause D1 Access routes: Performance D1.3.3(b), D1.3.3(d)
- Clause F2 Hazardous building materials: Performance F2.3.1
ALUMAT AL10 I meets the relevant standards
Fire safety tested EN ISO 9239-1 (2010) CRF 8.0KW/m2
Slip resistance. Exceeds minimum slip resistance of0.4 in both wet and dry conditions.
The product meets the requirements set out in the following documents, or relevant parts of cited standards within the documents:
Fire safety test results of EN ISO 9239-1 (2010) CRF 8.0Kw/m2 by Universiteit Gent
The product has and can make available the following additional evidence to support the above statements:
Use in Service History
Infill materials manufactured by Vebe, Netherlands have been in use for heavy duty entrances for many years in Europe and Worldwide.
Alumat AL10 Interlock is the ideal choice where a 10mm high profile entrance mat is required in intense wear situations.
It can be fitted into a recessed mat well, or be fitted with our unique ramping option. Our ramping is unlike others, coming preinstalled. This means our mitred corners of ramping if required are perfectly aligned and locked in place. There is no need to drill holes to secure the ramps saving unsightly screw fixings, ill fitting joints and holes and plugs to the floor.
Maintenance instructions available on our web site, or on request.
Alumat mats are all guaranteed for a minimum of 5 years.
This applies for both infills and aluminium bases, Extrusions are exterior grade and anodised, so if installed correctly and maintained will last for many years.
Infills are hard wearing polypropylene. While they too are exceptionally hard wearing, to keep entrances looking at their best, replacement of infills is possible and recommended after 5 to 10 years of use although they will continue to wear and perform beyond that time.
All of the products used are manufactured by companies that have demonstrated their commitment to the environment and have been appropriately certified.
We have selected aluminium that is designed to withstand wet conditions and can be reused after refurbishment if in suitable condition. Our heavier grade extrusions AL15 and AL20 are guaranteed to be able to be reconditioned for the first 10 years of their life, but you can expect much longer.
See Products Guarantee