The SUMNER Natural Stone Cladding System (SUMNER System) uses a fibre-cement board as the cladding substrate onto which is adhered a selected natural stone veneer. Sumner (fibre-cement) Board is fixed to timber or steel framing by way of 10g x 60mm stainless steel screws at 220mm centers applied around the perimeter and centre of the board. In order to ensure the board meets the durability requirements, the board is primed on the face. To prevent the ingress of moisture at vertical junctions, a specialized board tape is used, and for inter-storey junctions, the tape is used in place of z flashings .
Scope of use
SUMNER is direct fix unless used as a cladding, in which case we supply our own proprietary cavity system (rigid backer and cavity battens).
Up to 3 storeys, or 10m to top of chimney
With floor plan area limited only by seismic and structural control
External walls that are vertical, and roofs that are 60º or less
above the horizontal, and
Buildings that require specific design input must have framing
stiffness equal to the framing provisions of NZS 3604, and
frame constructions complying with the NZBC, and
frame constructions must be to a specific design meeting the
requirements of the
NASH 3405, and
constructions complying with NZS3604:2011, and
for residential and commercial applications, in locations where the
maximum wind zone is determined to be less than or equal to very
New Zealand Building Code (NZBC)
The product will, if employed in accordance with the supplier's installation and maintenance requirements, assist with meeting the following provisions of the building code:
- Clause B1 Structure: Performance B1.3.2, B1.3.3, B1.3.3(a), B1.3.3(f)
- Clause B2 Durability: Performance B2.3.1(a), B2.3.1(b), B2.3.1(c)
- Clause E2 External moisture: Performance E2.3.2
- Clause F2 Hazardous building materials: Performance F2.3.1
The product meets the requirements set out in the following documents, or relevant parts of cited standards within the documents:
SUMNER Board complies with AS/NZS 2908.2:2000, and
NZBC clause B1
The product has and can make available the following additional evidence to support the above statements:
Used for cladding of steel, timber frame and masonry buildings, with wind speed up to 50 m/s (Very High). Use our Codemark for ease of compliance.
Unlimited use any landscaping application
SUMNER System must only be installed on vertical surfaces in
accordance with the Technical Literature.
for locations where the maximum wind zone is determined to be less
than or equal to very high (50m/s),
or where specific design is employed.
SUMNER Schist cladding system is to be used for High-wind zones a
Rigid Air Barrier compliant with NZBC must be employed.
has also been appraised for weather tightness and structural wind
loading when used for timber or steel framed buildings subject to
specific design up to a design differential ultimate limit state
(ULS) wind pressure of 2500Pa.
buildings, and chimneys no higher than 10 meters above ground level.
||New Zealand Made
||Future Proof Building